Buckle - 1st Row - LH (Remove and Replace)
校正代码
20054702
0.30
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure wearing proper PPE when
performing the below procedure.
扭矩规格
描述 | 扭矩值 | 推荐工具 | 重复使用/更换 | 备注 |
---|---|---|---|---|
Patchbolt that attaches the buckle to the seat track |
![]() 40 Nm (29.5 lbs-ft) |
|
更换 | 1117250-00-A |
拆卸
- Remove the inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Disconnect the electrical connector from the LH 1st row buckle.
- Release the harness clip from the seat bottom frame.
-
Remove and discard the
patchbolt that attaches the buckle to the seat track, and then remove the
buckle.
TIp推荐使用以下工具:
- 梅花 T50 套筒
- 3/8 英寸标准棘轮
- 3/8 英寸扭矩扳手(仅适用于安装程序)
- 3 英寸加长件
安装
-
Install the patchbolt that
comes with the new seat belt buckle to attach the buckle to the seat
track.40 Nm (29.5 lbs-ft)CAUTIONMake sure to engage the pin on the buckle with the slot in the seat track.TIp推荐使用以下工具:
- 梅花 T50 套筒
- 3/8 英寸标准棘轮
- 3/8 英寸扭矩扳手(仅适用于安装程序)
- 3 英寸加长件
- Connect the electrical connector from the LH 1st row buckle.
- Connect 12V power. See 12V/LV Power (Disconnect and Connect).
- Raise the seat to its highest position while inspecting the seat belt buckle harness with a flashlight to make sure its not catching on anything.
- Make sure the seat belt buckle harness is routed in front of the datum and not around the datum.
- With the seat still at its highest position, adjust and secure the seat belt buckle harness clip along the inner seat rail and verify the harness is extended as far forward as possible to eliminate slack on the back side of the clip.
- Fully raise and lower the seat, inspecting the seat belt buckle harness with a flashlight to make sure its not catching on anything.
- Install the inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).