Trim - A-Pillar - Lower - LH (Remove and Replace)
校正代码
15182402
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure wearing proper PPE when
performing the below procedure.
拆卸
- 打开 LH 前车门。
- 拆下 LH 仪表板端盖。请参阅End Cap - Instrument Panel - LH (Remove and Replace)。
- 拆下 A 柱 LH 中部饰板。请参阅Trim - A-Pillar - Middle - LH (Remove and Replace)。
- 松开 A 柱 LH 下部饰板顶端的夹子。
-
将 A 柱 LH 下部饰板末端向上拉,以便松开夹子和锁片,然后将整个饰板向后拉,以便从车上拆下饰板。
注从 LH A 柱和门槛区域拆下所有剩余的 A 柱 LH 下部饰板夹,如果稍后将安装 A 柱 LH 下部饰板,请拆下全部饰板夹。
安装
安装程序与拆卸程序相反,以下各项除外:
- 如果重新使用同一块 A 柱 LH 下部饰板,请在饰板上安装新夹子。
- 确保饰板前部的锁片稳妥锁入,饰板与 A 柱紧密贴合。
- 确保车门密封条覆盖 A 柱 LH 下部饰板。