Speaker - Dash - Center (Remove and Replace)
校正代码
21211602
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure wearing proper PPE when
performing the below procedure.
扭矩规格
描述 | 扭矩值 | 推荐工具 | 重复使用/更换 | 备注 |
---|---|---|---|---|
将前围板中间扬声器固定到仪表板支架的螺钉 |
![]() 2.3 Nm (1.7 lbs-ft) |
|
重复使用 |
拆卸
- 拆下 LH 和 RH 仪表板端盖。请参阅End Cap - Instrument Panel - LH (Remove and Replace)。
- 拆下A 柱 LH 和 RH 中部饰板。请参阅Trim - A-Pillar - Middle - LH (Remove and Replace)。
- 拆下 A 柱 LH 和 RH 上部饰板。请参阅Trim - A-Pillar - Upper - LH (Remove and Replace)。
- 拆下仪表板扬声器格栅。请参阅Grille - Speaker - Instrument Panel (Remove and Replace)。
-
拆下将中间围板扬声器固定到仪表板的螺钉,然后从仪表板上拆下扬声器。2.3 Nm (1.7 lbs-ft)
- 断开电气连接器与中间围板扬声器连接器的连接,然后从车上拆下扬声器。
安装
安装程序与拆卸程序相反。