2026-11-05

Speaker - Pedestrian Warning (Retrofit)

校正代码 17541006 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure. NOTE: See 人体工程学注意事项 for safe and healthy working practices.

  • 2026-04-02: Added step to run pws-equipped action.
  • 2026-01-26: Updated the configuration change routine to align with the latest software version and added the software reinstallation step.

扭矩规格

Table 1. 扭矩规格： Speaker - Pedestrian Warning (Retrofit)
描述 扭矩值 推荐工具 重复使用/更换 备注
将行人警示扬声器总成固定到前饰板的螺钉（3 个）
1.8 Nm (1.3 lbs-ft)
  • T25 梅花套筒
 重复使用

程序

  1. Remove the RH front wheel. See 轮毂（拆卸和安装）.
  2. Remove the clips (x9) that hold the RH front wheel liner to fascia, and move the wheel liner aside for access.
  3. Look underneath the RH front corner of the vehicle and locate the breakout harness for the pedestrian warning speaker electrical connector.
    Note
    If the vehicle is not equipped with the pedestrian warning speaker electrical connector, then the vehicle cannot be retrofitted with the pedestrian warning speaker. Reinstall the components that were removed for access and stop this procedure.
  4. Use a retractable blade knife or similar tool to carefully remove the tape that secures the pedestrian warning speaker electrical connector to the main front harness bundle.
  5. Install the screws (x3) that attach the pedestrian warning speaker assembly to the front fascia.
    1.8 Nm (1.3 lbs-ft)
    Tip
    推荐使用以下工具
    • T25 梅花套筒
  6. Install the clip that attaches the harness to the pedestrian warning speaker assembly.
  7. Engage the locking tab to connect the pedestrian warning speaker connector.
  8. Install the clips (x9) that hold the RH front wheel liner to fascia.
  9. Install the RH front wheel. See 轮毂（拆卸和安装）.
  10. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox（连接和断开）.
  11. Run ODIN routine PROC_ICE_X_SET-PEDESTRIAN-WARNING-SPEAKER-CONFIGvia Toolbox:(link)
  12. In Toolbox, run the pws-equipped action to enable the speaker.
  13. Disconnect the laptop.
  14. Reinstall the vehicle firmware. See 软件重新安装 - 触摸屏.
  15. Exit Service Mode. See 维护模式.
  16. Raise the LH front window and close the LH front door.