2021-12-26

Sensor - Impact Accelerometer - C-Pillar - LH (Remove and Replace)

校正代码 20200702 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
警告
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see 气囊和辅助约束系统 (SRS) 预防措施.

拆卸

  1. 打开全部车门。
  2. 降下全部车窗。
  3. 拆下第二排下部座垫。请参阅Seat Cushion - Lower - 2nd Row (Remove and Replace)
  4. 拆下前备箱后部挡板。请参阅Underhood Apron - Rear (Remove and Replace)
  5. 断开 12V 电源。请参阅12V/LV Power (Disconnect and Connect)
  6. 拆下第二排座椅 LH 侧承梁。请参阅Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)
  7. 拆下 LH 后部门槛板饰板。请参阅Trim - Sill Panel - Rear - LH (Remove and Replace)
  8. 拆下将充电接口线束支架固定到车身的螺栓,然后从 C 柱上移开充电接口线束。
    10 Nm (7.4 lbs-ft)
  9. 断开电气线束与气囊传感器连接器的连接。
  10. 拆下将气囊传感器固定到 C 柱的螺栓,然后从车上拆下传感器。
    8 Nm (5.9 lbs-ft)

安装

安装程序与拆卸程序相反。