Handle - Exterior Release - Door - Front - LH (Remove and Replace)
校正代码
11451002
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure wearing proper PPE when
performing the below procedure.
扭矩规格
描述 | 扭矩值 | 推荐工具 | 重复使用/更换 | 备注 |
---|---|---|---|---|
将左前车门外侧释放把手固定到车门的螺母 |
![]() 7 Nm (5.2 lbs-ft) |
|
重复使用 |
拆卸
- 拆下 LH 前门饰板。请参阅Panel - Door Trim - Front - LH (Remove and Install)。
- 拆下 LH 前门内侧密封条。请参阅Seal - Inner Belt - Front Door - LH (Remove and Replace)。
- 拆下 LH 前门玻璃。请参阅Glass - Door - LH - Front (Remove and Replace)。
- 拆下 LH 前门封闭板。请参阅Closeout Panel - Door - Front - LH (Remove and Install)。
- 断开线束与车门把手连接器的连接。
- 拆下遮盖车门把手螺母的螺塞。
-
拆下将车门把手固定到车门的螺母,然后从车门上拆下把手。7 Nm (5.2 lbs-ft)TIp推荐使用以下工具:
- 10 毫米套筒
- 1/4 英寸标准棘轮
- 1/4 英寸扭矩扳手(仅适用于安装程序)
- 6 英寸加长件
安装
安装程序与拆卸程序相反,以下各项除外:
- 安装新把手后,或拆下的把手安装到新车门上后,请执行把手调节作业。请参阅Handle - Exterior Release - Door - Front - LH (Adjust)。