09/03/2023 00:24:43

蓝牙低能耗胎压监测系统 (BLE TPMS)（改装）

校正代码 34040006 1.02 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则不要堆叠校正代码。注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。

改装

  1. Remove the TPMS sensor from the wheel. See 传感器 - 胎压监测系统（拆卸和更换）.
  2. Use an IPA wipe to thoroughly clean the inside and outside of the TPMS sensor mounting hole.
  3. Install the BLE TPMS sensor so that it fits closely to the wheel.
  4. Install the nut that secures the BLE TPMS sensor to the wheel.
    8 Nm (5.9 lbs-ft)
  5. Release the upper bead roller, and allow the bead to seat against the wheel.
  6. Inflate the tire to seat the bead.
  7. Install the valve stem core, and then remove the wheel from the tire changer.
  8. Rebalance the wheel. See 轮胎 - 前 - LH（平衡）.
  9. Reinstall the wheel. See 轮毂总成（拆卸和安装）.
  10. Repeat steps 1 through 9 for all wheels.
  11. Update the Vehicle Configuration. See 蓝牙低能耗胎压监测系统 (BLE TPMS)（更新配置）.
  12. Test drive the vehicle to at least 15 mph (24 kph) for 1-3 minutes to reconnect the TPMS sensors.
  13. Confirm on the vehicle touchscreen that all 4 TPMS sensors are providing tire pressure readings.