2022-06-20

Bracket - Headlight - LH (Remove and Replace)

校正代码 17400112 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure.

  • 1080559-20-A TOOL, TORQUE SCREWDRIVER, 0.8-2.0NM (NA, APAC)
  • 1080559-21-A TOOL, TORQUE SCREWDRIVER, 0.8-2.0NM (EMEA)

扭矩规格

表 1. 扭矩规格: Bracket - Headlight - LH (Remove and Replace)
描述 扭矩值 推荐工具 重复使用/更换 备注
Screws that attach the headlight bracket to the headlight
1.8 Nm (1.3 lbs-ft)
  • Torx T25 socket
  • 6 in extension
重复使用

拆卸

Informational PurposesAn informational icon, calling your attention
如果大灯支架不能用作独立的可维修零件,则应更换大灯总成(包括支架)。
  1. 拆下大灯。请参阅Headlight - LH (Remove and Replace)
  2. 拆下将支架固定到大灯的螺钉,然后从大灯上拆下支架。
    Informational PurposesAn informational icon, calling your attention
    推荐使用以下工具:
    • Torx T25 socket
    • 6 in extension

安装

  1. 安装将支架固定到大灯的螺钉。
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    推荐使用以下工具:
    • Torx T25 socket
    • 6 in extension
  2. 安装大灯。请参阅Headlight - LH (Remove and Replace)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    安装大灯后,确保对其进行调试。