2025-06-17
转向柱 - 检查横向间隙 (Inspection)
校正代码 32051900 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure.
- 2025-02-18: Added video.
- 2025-02-06: Released new procedure.
Inspection
-
Move the steering column to the highest and most inward position.
注On the touchscreen, select, and then use the left scroll wheel on the steering wheel to adjust the steering column.
- Set the steering wheel in straight ahead position.
-
Perform a pull/wiggle test
on the steering wheel: gently pull and push the steering wheel away from and
towards the steering column and note any unusual movement.
- If any unusual
movement is observed, install a new steering wheel bolt that attaches
the steering wheel to the steering column and torque it to specification
before continuing to the next step. See Steering Wheel (Remove and Install). Make sure there
is no more unusual movement of the steering wheel, and then continue to
step 4.注Add correction code 32051801 as a separate activity to the Service Visit.
- If no unusual movement is observed, continue to the next step.
- If any unusual
movement is observed, install a new steering wheel bolt that attaches
the steering wheel to the steering column and torque it to specification
before continuing to the next step. See Steering Wheel (Remove and Install). Make sure there
is no more unusual movement of the steering wheel, and then continue to
step 4.
- Apply tape onto steering wheel at the 3 o'clock position and put protective material onto the center console.
-
Set the touchscreen to
Screen Cleaning Mode, and then install the brake rotor run-out tool onto the
center display and steering wheel.
注Install the suction cup onto the center display. Apply masking tape onto the suction cup for protection, then install the brake run-out tool onto the suction cup. Align the tool horizontally with the tape on the steering wheel and at the 3 o'clock position.注Make sure that the indicator rod is properly depressed and allows travel in both directions without bottoming out. Set dial to zero.
-
Inspect the steering column for lateral play.
警告The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
- Remove the brake rotor run-out tool from the center display.
- Remove protective materials from the steering wheel and center console.
- Clean the center display, and then exit Screen Cleaning Mode.