2025-06-27

Fascia Assembly - Rear - Partially Remove (Mobile Only) (Remove and Install)

교정 코드 10010501701 0.30 바고: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 ServiceManualFeedback@tesla.com으로 이메일을 보내십시오. 참고: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오.참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

  • 2025-06-11: Released new procedure.

탈거

  1. Release the rear half of the LH and RH rear fender garnish from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    참고
    6x clips, 2x tabs. Release from center of garnish and work your way outward towards the rear. Use a clip prytool to release the clips at the rear of the fascia to avoid damage to the garnish.
  2. Open the liftgate.
  3. Apply masking tape around the LH corner of the rear upper fascia.
  4. Partially release the LH rear trough trim.
    Informational PurposesAn informational icon, calling your attention
    참고
    3x clips
  5. Remove the bolt that attaches the LH corner of the rear fascia to the body.
  6. Remove the screw that attaches the LH rear fascia to the body.
  7. Repeat steps 3 through 6 at the RH side of the vehicle.
  8. Release rear fascia diffuser
    Informational PurposesAn informational icon, calling your attention
    참고
    2x fastener covers, 7x bolts, 6x push clips.
  9. Release the rear fascia assembly from the body and tilt it down onto a foam pad.
    Informational PurposesAn informational icon, calling your attention
    참고
    1x connector. Place the rear fascia on a padded surface to avoid damage.

장착

Installation procedure is the reverse of removal, except for the following:
  • Apply threadlocker to the bolts (x7) that attach the rear fascia diffuser to the vehicle.