2026-03-12

Door - Charge Port (CCS2) (Model Y L) (RHD) (Remove and Replace)

교정 코드 NEW 1.08 메모: 절차에서 명시적으로 언급하지 않는 한 위에 나열된 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 메모: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

탈거

  1. Remove the charge port assembly. See Charge Port (CCS2) (Model Y L) (RHD) (Remove and Replace).
  2. Disconnect the charge port harness connector from the charge port ECU.
  3. Release the charge port door harness grommet from the body.
  4. Release the lower clips (x2) that attach the charge port door to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the bottom clips, then push the bottom of the charge port door out.
  5. Gently pull the charge port door away from the body to remove the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the assembly towards the rear of the vehicle. When the door actuator reaches to the rear of the quarter panel, pull the charge port down to clear the actuator mechanism, then pull out and away from the body. Manipulation of the charge port door may be necessary to fully remove the assembly.

장착

  1. Install the charge port door onto the vehicle (2x clips).
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the part by pivoting the assembly so the actuator mechanism clears underneath the quarter panel, then slide the charge door forward toward the rear door. Manipulation of the charge door may be necessary to fully align the assembly to the body.
  2. Secure the charge port door harness grommet to the body.
  3. Connect the charge port door connector to the charge port ECU.
  4. Install the charge port assembly. See Charge Port (CCS2) (Model Y L) (RHD) (Remove and Replace).