교정 코드 1309010701 1309010702메모: 절차에서 명시적으로 언급하지 않는 한 위에 나열된 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오.참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 메모: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

1. Open all four doors

   

2. Lower all four windows

   

3. Open liftgate

   

4. Remove trunk load floor from vehicle

   

5. Move LH front seat forward

   

6. Position 60 seat into easy entry mode
   참고

   Press shoulder switch and push 60 seat forward to position into easy entry mode

   

   

7. Move RH front seat forward

   

8. Position 40 seat into easy entry mode
   참고

   Press shoulder switch and push 40 seat forward to position into easy entry mode

   

   

9. Remove 3rd row seat cushion and disconnect harness
   참고

   1x connector, Pull LH and RH release lever under 3rd row seat cushion to release seat cushion

   

   

   

10. Remove 3rd row LH seat cushion bolster
    참고

    1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster towards front of vehicle to remove

    

11. Remove LH outer cover
    참고

    1x clip, 1x tablift/pry front then rear to release cover, slightly recline seat forward for easy removal of rear clip, then push from rear to remove from inner cover.

    

    

    

    

12. Install LH outer cover
    참고

    1x clip, 1x TabInsert outer cover into position and engage rear clip, re-engage front tab of outer cover

    

    

    

13. Install 3rd row LH seat cushion bolster
    참고

    1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster into seat frame complete

    

    

14. Install 3rd row seat cushion and connect harness
    참고

    1x connector, Secure 3rd row seat cushion into RH and LH latches

    

    

15. Move 60 seat to original position

    

16. Move LH front seat to original position

    

17. Move 40 seat to original position

    

18. Install trunk load floor onto vehicle

    

    

19. Move RH front seat to original position

    

20. Close liftgate

    

    

    

21. Raise all four windows
    참고

    Via LH front door switch

    

22. Close all four doors
    참고

    Unlatch doors before closing if necessary