2026-05-28

Power Strut - Liftgate - LH (Model Y Standard) (Remove and Replace)

교정 코드 11332902602 FRT 0.24 메모: 절차에서 명시적으로 언급하지 않는 한 위에 나열된 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 메모: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

  • 2026-05-07: Released new procedure.

탈거

  1. Open the liftgate and support it with a telescoping hood prop.
  2. Fold 2nd row LH seatback down
    Informational PurposesAn informational icon, calling your attention
    참고
    Protect seat back upholstery if necessary
  3. Remove the LH rear body primary seal. See Primary Body Seal - Rear - LH (Remove and Replace).
  4. Partially remove the LH trunk side trim. See Trunk Side Trim LH - Rear Under Body (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    참고
    Release only the upper section of trim, Use caution to avoid straining 12v socket harness at rear of trim, All clips and datums shown in image for clarity
  5. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  6. Release the rear LH section of the headliner.
    Informational PurposesAn informational icon, calling your attention
    참고
    3x clips, 1x guide pin, Pull down as required to provide access to power strut connector.
  7. Disconnect the power strut connector from the body harness.
  8. Release the LH rear power strut harness grommet from the body.
  9. Release the LH upper power strut clip from the liftgate side ball stud, and lay the power strut down on the door jamb.
  10. Release the power strut clip from the body side ball stud.

장착

  1. Install the power strut clip to the body side ball stud.
    Informational PurposesAn informational icon, calling your attention
    참고
    Ensure that the spring clip is reset.
  2. Install the power strut clip to the liftgate side ball stud.
    Informational PurposesAn informational icon, calling your attention
    참고
    Ensure that the spring clip is reset.
  3. Remove the telescoping hood prop from the vehicle.
  4. Insert the power strut harness into the body and install the grommet.
  5. Connect the power strut harness connector.
  6. Install the rear LH section of the headliner.
  7. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  8. Secure the LH trunk side trim. See Trunk Side Trim LH - Rear Under Body (Remove and Replace).
  9. Install the LH rear body primary seal. See Primary Body Seal - Rear - LH (Remove and Replace).