2023-10-20

CloseOut - Center Console ((拆卸和更换))

校正代码 1519010032 FRT 0.42 注意:除非本程序中另有明确规定,否则上述校正代码和 FRT 反映的是执行本程序(包括关联程序)所需的所有工作。除非明确要求,否则请勿堆叠校正代码。 注意:请参阅平均维修工时,深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈,请发送电子邮件至ServiceManualFeedback@tesla.com 注意:请参阅人员保护,确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。

  • 1060071-00-A 1/4 英寸六角扭矩扳手

扭矩规格

表 1. 扭矩规格CloseOut - Center Console ((拆卸和更换))
描述 扭矩值 推荐工具 重复使用/更换 备注
将中控台封闭板总成固定到中控台的螺钉
1 Nm (.7 lbs-ft)
  • 梅花 T20 套筒
  • 2 英寸加长件
  • 无绳棘轮/冲击钻
  • 1/4 英寸钻头六角扭矩扳手 - 1060071-00-A(仅适用于安装程序)
重复使用

拆卸

  1. 打开所有车门,降下所有车窗。
  2. 拆卸手机托盘总成。请参阅 Phone Dock (Clip) - Center Console ((拆卸和更换))
  3. 拆卸中控台后端面板。请参阅Panel - Rear End - Center Console ((拆卸和更换))
  4. 拆卸中控台左后面板。请参阅Panel - Rear Side - Center Console - LH ((拆卸和更换))
  5. 拆卸中控台左前面板。请参阅Carpet - Side - Center Console - LH ((拆卸和更换))
  6. 拆卸中控台左侧饰板。请参阅Decor Trim - Center Console - LH ((拆卸和更换))
  7. 拆卸中控台右后面板。请参阅Panel - Rear Side - Center Console - LH ((拆卸和更换))
  8. 拆卸中控台右前面板。请参阅Carpet - Side - Center Console - RH ((拆卸和更换))
  9. 拆卸中控台右侧饰板。请参阅Decor Trim - Center Console - LH ((拆卸和更换))
  10. 拆卸中控台上面板。请参阅Top Panel - Center Console ((拆卸和更换))
  11. 拆卸中控台垃圾箱滑盖总成。请参阅Sliding Door Assembly - Center Console ((拆卸和更换))
  12. 拆卸将中控台封闭板总成固定到中控台的螺钉。
    Informational PurposesAn informational icon, calling your attention
    TIp
    推荐使用以下工具:
    • 梅花 T20 套筒
    • 2 英寸加长件
    • 无绳棘轮/冲击钻
    • 1/4 英寸钻头六角扭矩扳手 - 1060071-00-A(仅适用于安装程序)
  13. 将中控台地面照明灯电气线束从中控台封闭板连接器上断开,然后将中控台封闭板从中控台上拆下。
    Informational PurposesAn informational icon, calling your attention
    将中控台封闭板垂直向上拉起,使其从固定销(3 个)上脱离。

安装

  1. 将中控台封闭板安装到中控台上,然后将中控台地面照明灯电气线束与中控台封闭板连接器相连。
    Informational PurposesAn informational icon, calling your attention
    安装中控台封闭板时,注意对齐固定销孔(3 个)。
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    确保正确安装连接器。继续此程序前,先执行推拉测试。
  2. 安装将中控台封闭板总成固定到中控台的螺钉。
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    推荐使用以下工具:
    • 梅花 T20 套筒
    • 2 英寸加长件
    • 无绳棘轮/冲击钻
    • 1/4 英寸钻头六角扭矩扳手 - 1060071-00-A(仅适用于安装程序)
  3. 安装中控台垃圾箱滑盖总成。请参阅Sliding Door Assembly - Center Console ((拆卸和更换))
  4. 安装中控台上面板。请参阅Top Panel - Center Console ((拆卸和更换))
  5. 安装中控台右侧饰板。请参阅Decor Trim - Center Console - LH ((拆卸和更换))
  6. 安装中控台右前面板。请参阅Carpet - Side - Center Console - RH ((拆卸和更换))
  7. 安装中控台右后面板。请参阅Panel - Rear Side - Center Console - LH ((拆卸和更换))
  8. 安装中控台左侧饰板。请参阅Decor Trim - Center Console - LH ((拆卸和更换))
  9. 安装中控台左前面板。请参阅Carpet - Side - Center Console - LH ((拆卸和更换))
  10. 安装中控台左后面板。请参阅Panel - Rear Side - Center Console - LH ((拆卸和更换))
  11. 安装中控台后端面板。请参阅Panel - Rear End - Center Console ((拆卸和更换))
  12. 安装手机托盘总成。请参阅 Phone Dock (Clip) - Center Console ((拆卸和更换))
  13. 升起所有车窗,关闭所有车门。