2026-08-09

支架 - 车牌 - 前 (NA) ((拆卸和更换))

校正代码 1207010012 FRT 0.12 注意：除非本程序中另有明确规定，否则上文所列校正代码及相关 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时深入了解 FRT 及其创建方式。 注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。 注意：请参阅人体工程学注意事项查看安全健康的作业规程。

拆卸

  1. Remove front license plate from license plate bracket.
    注
    4x screws, PH2, 3 Nm
  2. Apply masking tape around front license plate bracket.
  3. Remove front license plate bracket.
  4. Clean surface area of front license plate bracket on front fascia.
    注
    Allow one minute dry time.

安装

  1. Use the center grille rib as a reference point, then align tape centrally onto center mold injection onto bracket up to T badge.
  2. Remove backing from horizontal double-sided tape and top portion of vertical double-sided tapes, bending it outboard of the bracket.
  3. Install front license plate bracket onto fascia.
    注
    Position front license plate bracket onto fascia, Remove remaining backing from double-sided tape
  4. Press license plate bracket onto fascia to wet-out double-sided tape.
  5. Verify curvature is flush onto fascia.