2026-10-15

Tie Rod - Inner and Outer - LH (Remove and Replace)

校正代码 32013202 注意：除非本程序中另有明确规定，否则上文所列校正代码及相关 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时深入了解 FRT 及其创建方式。 注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。 注意：请参阅人体工程学注意事项查看安全健康的作业规程。

  • 2026-09-21: Released new procedure.

拆卸

  1. Remove the LH wheel arch liner. See aise and support the vehicle. See 轮拱内衬 - 前 - 左侧 ((拆卸和更换)).
  2. Remove and discard the nut that attaches the LH tie rod outer assembly to the LH front knuckle.
  3. Remove the LH front tie rod end from the LH front knuckle.
  4. Remove and discard the large bellows clamp from the bellows.
  5. Remove the bellows seal clip from the bellows.
  6. Slide the bellows toward the LH outer tie rod end.
  7. Remove the LH tie rod assembly from the pinion housing.
    注
    38mm crowfoot. Twist until it comes off.

安装

  1. Adjust the new tie rod length to match old tie rod before installation.
    注
    1x jam nut, 21mm, 14mm. Turn inner tie rod as needed. Parts line up is to count the threads on the removed tie rod then adjust to the same count on the new one. This will make alignment adjustment easier.
  2. Install the LH inner tie rod assembly onto the pinion housing.
    88 Nm (64.9 lbs-ft)
    注
    Use a 38 mm crowfoot. Twist until it's fully seated.
  3. Slide the bellows into the clamping position.
  4. Install the large bellows clamp onto the bellows.
  5. Install the bellows seal clip onto the bellows.
  6. Position the LH tie rod outer assembly to the LH front knuckle.
  7. Install a new nyloc nut that attaches the LH tie rod outer assembly to the LH front knuckle.
    180 Nm (132.7 lbs-ft)
  8. Install the LH front wheel liner. See 轮拱内衬 - 前 - 左侧 ((拆卸和更换)).
  9. Install the LH front wheel. See 轮毂总成（拆卸和安装）.
  10. Review the wheel alignment requirements and add correction code(s) as needed. See 定位要求 - 悬架.