02/04/2023 20:17:00

面板 - 流线型护板 - 前(拆卸和更换)

校正代码 12030102 0.24 注意:除非本程序中另有明确规定,否则上述校正代码和 FRT 反映的是执行本程序(包括关联程序)所需的所有工作。除非明确要求,否则请勿堆叠校正代码。 注意:请参阅平均维修工时,深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈,请发送电子邮件至LaborTimeFeedback@tesla.com 注意:执行下述程序时,请参阅人员保护确认已穿戴适当的个人防护装备 (PPE)。

Warning IconA warning icon, calling your attention to a possibly risky situation
警告
尽管此程序已经过验证,但仍是一个草案。可能没有警告和注意事项。请遵守安全要求,处理或靠近高压系统和部件时,请谨慎操作。请将校正修理内容及反馈发送至ServiceDevelopment@teslamotors.com

拆卸

  1. Raise and support the vehicle on a 2 post lift. See 举升车辆 - 双柱举升机.
  2. Release the push clips (x2) that attach the front aero shield panel to the LH and RH front wheel arch liners.
  3. Release the push clips (x3) that attach the front aero shield panel to the underbody.
  4. Remove the bolts (x9) that attach the front aero shield panel to the front subframe, and then remove the panel from the vehicle.

安装

  1. Apply a drop of Loctite 222 onto the threads of each front aero shield panel bolt.
  2. Install the front aero shield panel to the front subframe, and then install the bolts (x9) that attach the panel to the subframe.
    6 Nm (4.4 lbs-ft)
  3. Fasten the push clips (x3) that attach the front aero shield panel to the underbody.
  4. Fasten the push clips (x2) that attach the front aero shield panel to the LH and RH front wheel arch liners.
  5. Remove the vehicle from the lift. See 举升车辆 - 双柱举升机.