03/04/2023 14:23:15

开关 - 盖板 - 中控台(拆卸和更换)

校正代码 15190612 0.54 注意:除非本程序中另有明确规定,否则上述校正代码和 FRT 反映的是执行本程序(包括关联程序)所需的所有工作。除非明确要求,否则请勿堆叠校正代码。 注意:请参阅平均维修工时,深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈,请发送电子邮件至LaborTimeFeedback@tesla.com 注意:执行下述程序时,请参阅人员保护确认已穿戴适当的个人防护装备 (PPE)。

拆卸

  1. Open all four doors.
  2. Lower the LH and RH front windows.
  3. Move the LH and RH front seats forward.
  4. Remove the center console lower rear panel. See 面板 - 下后部 - 中控台(拆卸和更换).
  5. Remove the 1st row center console assembly. See 中控台总成 - 第一排(拆卸和安装).
  6. Release the tabs (x3) that attach the center console lid switch harness to the 1st row center console assembly, and then remove the tape that attaches the switch harness to the harness bundle.
  7. Release the center console lid switch connector from the 1st row center console assembly, and then disconnect the switch connector.
  8. Remove the screw that attaches the center console lid switch to the 1st row center console assembly, and then remove the switch from the vehicle.
    提示: 推荐使用以下工具:
    • Mini ratchet bit set - 1450424-00-A

安装

  1. Position the center console lid switch on the 1st row center console assembly, and then install the screw that attaches the switch to the console.
    0.7 Nm (6 lbs-in)
    提示: 推荐使用以下工具:
    • Mini ratchet bit set - 1450424-00-A
    • 棘轮/扭矩扳手
  2. Connect the center console lid switch connector, and then install the connector on the 1st row center console assembly.
  3. Install the tabs (x3) that attach the center console lid switch harness to the 1st row center console assembly. Use tape to attach the switch harness to the harness bundle.
    提示: 推荐使用以下工具:
    • Harness tape
    • Scissors
  4. Install the 1st row center console assembly. See 中控台总成 - 第一排(拆卸和安装).
  5. Install the center console lower rear panel. See 面板 - 下后部 - 中控台(拆卸和更换).
  6. Move the LH and RH front seats to original position.
  7. Raise the LH and RH front windows.
  8. Close all four doors.