Wiper Arm - LH (Remove and Replace)
校正代码
17500302
0.05
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See 平均维修工时 to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 人员保护 to make sure proper PPE is worn when
performing the below
procedure.
- 2025-01-28: Corrected torque value for wiper arm nut from 32 Nm to 25 Nm.
拆卸
- Open the LH front door and lower the LH front window.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Release the LH wiper arm hose nozzle.
- Remove the LH wiper arm nut cover.
-
Remove the nut that attaches the LH
wiper arm to the vehicle, and then use a wiper arm removal tool to remove the wiper arm
from the vehicle.
警告Do not flex the wiper arm to remove it.注Lower the hood slightly to fit the wiper arm removal tool.TIp推荐使用以下工具:
- 15 毫米套筒
- Wiper Arm Removal Tool - 1058696-00-A
安装
-
Position the LH wiper arm into the
vehicle, and then install the nut that attaches the wiper arm to the vehicle.25 Nm (18.4 lbs-ft)TIp推荐使用以下工具:
- 15 毫米套筒
- Install the LH wiper arm nut cover.
- Attach the LH wiper arm hose nozzle.
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Raise the LH front window and close the LH front door.