2023-05-09

Cover - Hinge - Active Hood - LH (Remove & Replace)

校正代码 20302302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See 平均维修工时 to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 人员保护 to make sure proper PPE is worn when performing the below procedure.

拆卸

  1. Open the LH front door.
  2. Open the hood.
  3. Lower both front windows.
  4. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  5. Remove the clip that attaches the active hood hinge cover to the vehicle.
  6. Remove the active hood hinge cover: lift the cover over the strut and remove it upwards towards the windscreen.

安装

  1. Install the active hood hinge cover.
    Informational PurposesAn informational icon, calling your attention
    注
    Slide the cover down towards the cowl, and then install it over the strut.
  2. Install the retaining clip that attaches the active hood hinge cover to the vehicle.
  3. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).