2026-10-15

Tie Rod - Inner and Outer - LH (Remove and Replace)

교정 코드 32013202 메모: 절차에서 명시적으로 언급하지 않는 한 교정 코드 및 해당 관련 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 참고: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

  • 2026-09-21: Released new procedure.

탈거

  1. Remove the LH wheel arch liner. See aise and support the vehicle. See Wheel Arch Liner - Front - LH (Remove and Replace).
  2. Remove and discard the nut that attaches the LH tie rod outer assembly to the LH front knuckle.
  3. Remove the LH front tie rod end from the LH front knuckle.
  4. Remove and discard the large bellows clamp from the bellows.
  5. Remove the bellows seal clip from the bellows.
  6. Slide the bellows toward the LH outer tie rod end.
  7. Remove the LH tie rod assembly from the pinion housing.
    참고
    38mm crowfoot. Twist until it comes off.

장착

  1. Adjust the new tie rod length to match old tie rod before installation.
    참고
    1x jam nut, 21mm, 14mm. Turn inner tie rod as needed. Parts line up is to count the threads on the removed tie rod then adjust to the same count on the new one. This will make alignment adjustment easier.
  2. Install the LH inner tie rod assembly onto the pinion housing.
    88 Nm (64.9 lbs-ft)
    참고
    Use a 38 mm crowfoot. Twist until it's fully seated.
  3. Slide the bellows into the clamping position.
  4. Install the large bellows clamp onto the bellows.
  5. Install the bellows seal clip onto the bellows.
  6. Position the LH tie rod outer assembly to the LH front knuckle.
  7. Install a new nyloc nut that attaches the LH tie rod outer assembly to the LH front knuckle.
    180 Nm (132.7 lbs-ft)
  8. Install the LH front wheel liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  9. Install the LH front wheel. See 휠 어셈블리(탈거 및 장착).
  10. Review the wheel alignment requirements and add correction code(s) as needed. See 얼라인먼트 요구 사항 - 서스펜션.