2025-06-27

LV Battery - Recover (Restore)

교정 코드 17010008 FRT 0.06 바고: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 ServiceManualFeedback@tesla.com으로 이메일을 보내십시오. 참고: 아래 절차를 수행할 때 개인 보호을(를) 참조하여 적절한 PPE를 착용했는지 확인하십시오.

  • 2025-05-15: Updated procedure.

Recover

Informational PurposesAn informational icon, calling your attention
참고
The LV battery won't recover unless the HV system is healthy and supporting the vehicle. Make sure that the HV system is functioning correctly before attempting to recover the LV battery.
  1. Enable Service Mode. See 정비 모드.
  2. Make sure that no external power source is connected to the jump post.
  3. Make sure that the high voltage system is supporting the low voltage system. On the touchscreen, touch Service Mode > Low Voltage > Power Distribution and make sure that the PCS DCDC Support Status indicates Active.
  4. Make sure that the LV battery is properly connected. On the touchscreen, touch Service Mode > Low Voltage > Power Distribution and make sure that the Li-ion LV Battery ECPA (Electrical Connector Position Assurance) status indicates Closed.
  5. Confirm that the Li-ion LV battery MOSFET status is Closed. On the touchscreen, touch Service Mode > Low Voltage > Power Distribution and make sure that the Li-ion LV Battery MOSFET status indicates Closed (Green).
    그림 1. Li-ion LV Battery MOSFET status Closed
  6. If the MOSFET status is Open (Orange), the LV battery has not auto-recovered and alert VCFRONT_a478_LVBMS_MOSFET will be present. To attempt the MOSFET to close, 정비 모드 또는 Toolbox를 사용하여 다음 루틴을 수행합니다(참조 항목: 0005 - 정비 모드):PROC_VCFRONT_X_RECONNECT-LV-BATTERYvia Toolbox: (link)via Service Mode: Low Voltage ➜ Power Distribution ➜ Close MOSFET
    그림 2. Li-ion LV Battery MOSFET status Open
  7. If the previous step does not successfully recover the battery, proceed with using the Tesla LV Li-ion battery charger to recover the LV battery, and then repeat this procedure.
  8. Exit Service Mode. See 정비 모드.