2025-12-25

Deflector Clip - Tonneau - LH (Remove and Replace)

교정 코드 1120122172 0.80 메모: 절차에서 명시적으로 언급하지 않는 한 위에 나열된 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 메모: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
이 절차는 초안입니다. 따라서 검증은 되었지만 경고 및 주의 사항이 누락되었을 수 있습니다. 고전압 시스템 및 구성 요소에서 또는 그 근처에서 작업하는 경우에는 안전 요구 사항을 준수하고 최고 수준의 주의를 기울여야 합니다.
  • 2025-10-07: Released new procedure.

탈거

  1. Remove the tonneau slats. See Slat System - Tonneau (Remove and Install).
  2. Remove LH End Slat Bolt, Roller, Tonneau Service Kit
    Informational PurposesAn informational icon, calling your attention
    참고
    2x slat bolts, 2x sleeves, 4x rollers, 1x Y-React Clip, Carefully pull outwards to release slat bolts from slats

장착

  1. Install LH deflector clip
    Informational PurposesAn informational icon, calling your attention
    참고
    1x Clip,Insert into end slat.
  2. Install LH End Slat Bolt, Roller, Tonneau Service Kit
    Informational PurposesAn informational icon, calling your attention
    참고
    2x slat bolts, 2x sleeves, 4x rollers, 1x Y-React Clip, Insert slat bolts into slats until fully engaged
  3. Install the tonneau slats. See Slat System - Tonneau (Remove and Install). After Manually guiding the remaining tonneau slts and chain onto the bed rails, and before securing the tonneau chain onto the motors, perform the following steps:
    1. Re-establish vehicle connection to Toolbox 3.
    2. Select "Actions" tab and search for "Tonneau".
    3. Select "Tonneau Cover Calibration", click "Run", and allow routine to complete.
      Informational PurposesAn informational icon, calling your attention
      참고
      Select "X" at top right of window to close once complete.
    4. Disconnect Toolbox 3 from vehicle and remove laptop.