2026-08-09

Mud Flap - Rear - LH (Remove and Install)

교정 코드 12207401 12207402 12207601 12207602 FRT 0.12 메모: 절차에서 명시적으로 언급하지 않는 한 위에 나열된 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오. 메모: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

  • 2025-11-17: Added step to install U-nuts on earlier vehicles.

탈거

  1. Open the LH front door and lower the LH front window.
  2. Turn the steering wheel fully to the right to provide access to the working area.
  3. Remove the bolts (x3) that attach the LH rear mud flap to the LH rear wheel arch liner.
    Informational PurposesAn informational icon, calling your attention
    참고
    Early models may use clips instead of bolts.
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구 사용을 권장합니다.
    • 10mm 딥소켓
    • 코드리스 래칫/임팩트 드라이버
    • Clip pry tool (if the mud flap is secured with clips)
    그림 1. LH shown; RH similar
  4. Remove the bolt that attaches the LH rear mud flap to the LH rear diffuser, and then remove the mud flap from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구 사용을 권장합니다.
    • 10mm 딥소켓
    • 코드리스 래칫/임팩트 드라이버
    그림 2. LH shown; RH similar
    그림 3. LH shown; RH similar

장착

  1. If the mud flap was secured with clips instead of bolts, install U-nuts (x3) onto the LH rear.
    Informational PurposesAn informational icon, calling your attention
    참고
    Move the wheel arch liner as needed. Position the wheel arch liner before continuing.
  2. Position the LH rear mud flap on the vehicle, and then install the bolt that attaches the mud flap to the LH rear diffuser.
    2.2 Nm (1.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구 사용을 권장합니다.
    • 10mm 딥소켓
    • 코드리스 래칫/임팩트 드라이버
    • 각도 측정 토크 렌치
    그림 4. LH shown; RH similar
    그림 5. LH shown; RH similar
  3. Install the bolts (x3) that attach the LH rear mud flap to the LH rear wheel arch liner.
    2.2 Nm (1.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구 사용을 권장합니다.
    • 10mm 딥소켓
    • 코드리스 래칫/임팩트 드라이버
    • 각도 측정 토크 렌치
    그림 6. LH shown; RH similar
  4. Raise the LH front window and close the LH front door.