2026-08-27

横拉杆 - 内 - 左 ((拆卸和更换))

校正代码 32013202 32013302 FRT 0.48 注意：除非本程序中另有明确规定，否则上文所列校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时深入了解 FRT 及其创建方式。 注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。 注意：请参阅人体工程学注意事项查看安全健康的作业规程。

警告
本程序为“草案”。虽已通过验证，但可能仍有“警告”和“注意”事项缺失。请遵守安全要求，处理或靠近高压系统和部件时，请谨慎操作。
  • 2025-12-16: Released new procedure.

拆卸

  1. Remove the LH front wheel arch liner. See 轮拱内衬 - 前 - LH（非结构化电池组）（拆卸和更换） or 轮拱内衬 - 前 - LH（结构化电池组）（拆卸和更换）.
  2. Remove LH outer tie rod from knuckle
    注
    1x nyloc nut, 22mm, 180 Nm, Discard after removal
  3. Remove LH tie rod end from knuckle
  4. Remove large bellows clamp from bellows
    注
    1x clamp, Discard after removal
  5. Remove bellows seal clip from bellows
    注
    1x clip
  6. Slide bellows toward LH outer tie rod end
    注
    You need to access the LH inner tie rod end inner ball joint
  7. Remove LH tie rod assembly from pinion housing
    注
    1x inner tie rod, 38mm crowfoot, 88 Nm, Twist until it comes off

安装

  1. Adjusting new tie rod length to match old tie rod before installation
    注
    1x jam nut, 21mm, 14mm, Turn adjust inner tie rod as needed, Parts line up is to count the threads on the removed tie rod then adjust to the same count on the new one, This will make alignment adjustment easier
  2. Install LH inner tie rod assembly onto pinion housing
    注
    1x inner tie rod, 38 crowfoot, 88 Nm, Twist until it's fully seated
  3. Slide bellows into clamping position
    注
    Slide bellows over pinion housing in preparation for clamping
  4. Secure large bellows clamp onto bellows
    注
    1x clamp
  5. Secure bellows seal clip onto bellows
    注
    1x clamp
  6. Position LH tie rod end to LH front knuckle
  7. Install nut securing the LH tie rod end to the knuckle
    注
    1x nyloc nut, 22mm, 180 Nm, Install new nyloc nut
  8. Install the LH front wheel arch liner. See 轮拱内衬 - 前 - LH（非结构化电池组）（拆卸和更换） or 轮拱内衬 - 前 - LH（结构化电池组）（拆卸和更换）.
  9. Review wheel alignment requirements and add correction code as needed. See 定位要求 - 悬架.