18/05/2023 20:44:19

支架 - Rucket - LH（拆卸和更换）

校正代码 15306112 0.06 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。 注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。

拆卸

  1. Remove the LH load floor bracket. See 支架 - 后备箱负重底板- LH（拆卸和更换）.
  2. Remove the push clip that attaches the trunk tub liner LH rucket bracket, and then partially release the liner for access.
  3. Release the clips (x2) that attach the LH rucket bracket to the vehicle, and then remove the bracket from the vehicle.

安装

  1. Position the LH rucket bracket into the vehicle, and then install the clips (x2) that attach the bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    注
    Perform a push-pull-push test to verify the bracket is fully secure.
    Informational PurposesAn informational icon, calling your attention
    注
    The clip position should not be adjusted after bracket is removed or it will result in the bracket not seating properly. If the clip position is changed or the push-pull action shows the bracket is not secure, remove the clip from the tab, seat the clip into the doghouse on the bracket, and then reinstall.
  2. Move the trunk tub liner into the original position, and then install the push clip that attaches the liner to the rucket bracket.
  3. Install the LH load floor bracket. See 支架 - 后备箱负重底板- LH（拆卸和更换）.