05/10/2022 21:39:22
轮拱内衬 - 前 - LH（结构化电池组）（拆卸和更换）
校正代码
12010912 0.36 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。
拆卸
- Raise and support the vehicle. See举升车辆 - 双柱举升机.
- Remove the LH front wheel. See轮毂总成（拆卸和安装）.
- Raise the vehicle to a comfortable working height.
-
Remove the rocker bolt and aero shield bolts (x2) that attach the LH front wheel arch liner to the HV battery.
提示： Use of the following tool(s) is recommended:
- 10 mm socket
- Lower the vehicle partially.
- Remove the LH front fender garnish. See饰板 - 翼子板 - 前 - LH（拆卸和更换）.
-
Remove the push clips (x10 and metal clips (x5) that attach the LH front wheel arch liner to the vehicle.
注Metal clips are located behind the rotor.提示： Use a prytool to get cutters under the metal clip.
-
Release the LH front wheel arch liner from the studs (x5), and then remove the liner from the vehicle.
安装
-
Position the LH front wheel arch liner into the vehicle and onto the studs (x5), and then tuck the liner behind the front aero shield.
-
Install the push clips (x10) and metal clips (x5) that attach the LH front wheel arch liner to the vehicle.
注Use a socket to press the metal clip into the liner evenly.
- Install the LH front fender garnish. See饰板 - 翼子板 - 前 - LH（拆卸和更换）.
-
Apply Loctite 222 to the aero shield bolts (x2), and then install the aero shield bolts (x2) and rocker bolt that attach the LH front wheel arch liner to the HV battery.
12 Nm (8.8 lbs-ft)6 Nm (4.4 lbs-ft)注Torque the rocker bolt to 12 Nm and the aero shield bolts (x2) to 6 Nm.提示： Use of the following tool(s) is recommended:- 10 mm socket
- Install the LH front wheel. See轮毂总成（拆卸和安装）.
- Remove the vehicle from the lift.