15/01/2024 18:46:54
套管 - 前驱动单元 - RH（拆卸和更换）
校正代码
39011102 3.12 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈，请发送电子邮件至LaborTimeFeedback@tesla.com。注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。
拆卸
- Remove the front subframe assembly from the vehicle. See 副车架总成 - 前（双电机）（拆卸和安装）.
-
Install the bushing tool on the RH
front drive unit bushing.
注Use cups "K", "B", and "I" when assembling the special tool, as shown.
图 1. Other assemblies hidden for clarity 
-
Turn the bearing-side bushing tool nut
with a wrench while holding the opposite nut in place.
警告Apply torque only to the bearing-side bushing tool nut.
图 2. Apply torque only to the nut highlighted red 
-
When the bushing has been pushed out
of the front drive unit, separate the bushing tool, and then remove the bushing.
安装
-
安装套管工具，以套上新的套管。
注Use cups "L", "J", and "C" when assembling the special tool, as shown.注Make sure the rubber tab is visible at the top of cup "J".
图 3. Cups "L", "J", and "C" used to install the bushing 
图 4. Rubber tab visible at the top of cup "J" 
-
Turn the bearing-side bushing tool nut
with a wrench until the bushing flange makes contact with the front drive unit.
警告Apply torque only to the bearing-side bushing tool nut.注While installing the bushing, make sure the rubber tab remains visible at the top of cup "J".
图 5. Apply torque only to the nut highlighted red 
- 分离套管工具，然后从驱动单元上拆下。
-
Make sure the bushing alignment lug is
oriented to 12 o'clock.
图 6. Other assemblies hidden for clarity 
- Install the front subframe assembly on the vehicle. See 副车架总成 - 前（双电机）（拆卸和安装）.
- 检查车辆轮毂定位，并根据需要进行调整。请参阅四轮定位检查。