교정 코드 3310030002 FRT 0.24 참고: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 LaborTimeFeedback@tesla.com으로 이메일을 보내십시오. 참고: 아래 절차를 수행할 때 개인 보호을(를) 참조하여 적절한 PPE를 착용했는지 확인하십시오.

1. Raise and support vehicle
   참고

   Ensure vehicle is not charging

   

   

   

2. Remove LH front wheel center cap
   참고

   1x cap, Pull the inner side of the adjacent 2 claws on the wheel center cap by hands

   

   

3. Loosen LH front wheel nuts
   참고

   5x nuts, 21mm, 175 Nm

   

4. Raise vehicle partially and lower lift onto locks
   참고

   Set vehicle to a comfortable working height, Make sure there's an audible click of the locks on both sides before lowering, otherwise vehicle may tilt to the side

   

   

5. Remove LH front wheel
   참고

   5x nuts, 21mm, 175 Nm

   

6. Remove the clips that partially securing LH wheel liner to fascia
   참고

   9x push clips

   

7. Partially remove the LF wheel liner

   

8. Disconnect LH front wheel speed sensor connector
   참고

   1x connector, Disengage locking tab

   

   

9. Disconnect LH front damper solenoid connector
   참고

   1x connector, Disengage locking tab

   

10. Release clips securing LH front wheel speed sensor harness
    참고

    4x tree clips, 1x rubber grommet

    

11. Release bolt securing LH front wheel speed sensor to knuckle
    참고

    1x bolt, T30, 5 Nm

    

12. Remove LH front wheel speed sensor from knuckle

    

    

13. Install LH front wheel speed sensor into knuckle

    

    

14. Install bolt securing LH front wheel speed sensor to knuckle
    참고

    1x bolt, T30, 5 Nm

    

15. Install clips securing LH front wheel speed sensor harness
    참고

    4x tree clips, 1x rubber grommet, Ensure harness is routed correctly to avoid harness contact with moving suspension components

    

    

    

16. Connect LH front wheel speed sensor connector
    참고

    1x connector, Engage locking tab

    

17. Connect LH front damper solenoid
    참고

    1x connector, Engage locking tab

    

18. Install the LF wheel liner

    

19. Install clips securing LH wheel liner to fascia
    참고

    9x push clips

    

20. Install LH front wheel
    참고

    5x nuts, 21mm, 175 Nm, Start lug nuts by hand before using power tool

    

21. Lower vehicle until tires are touching ground
    참고

    Raise lift off locks, then hold lock release lever to keep locks free while vehicle is lowered

    

    

    

22. Torque LH front wheel
    참고

    5x nuts, 21mm, 175 Nm

    

23. Install LH front wheel center cap
    참고

    1x cap, Ensure that the cap is installed in place

    

24. Remove lift arms from below vehicle
    참고

    Lower rack arms fully and remove them from under vehicle