Rear Wheelhouse Front Stiffener
Correction code:
10101910902
10101911002
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | RR WHEEL ARCH RNFT, FR (Rear Wheelhouse Front Stiffener) | |
| 7 | High Strength Structural Rivet, 6.5 mm | |
| 1 | Bolt , M8x23.5 | Tesla part number 1063260-00-C. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Wheel Arch Liner - Rear - LH (Remove and Replace).
- Remove the Knuckle - Suspension - Rear - LH (Remove and Replace).
- Remove the Damper - Rear - LH (Remove and Replace).
- Remove the Subwoofer (Remove and Replace).
- Remove the Spring - Rear Suspension - LH (Remove and Replace).
- Remove the Drop Link - Stabilizer Bar - Rear - LH (Remove and Replace).
- Remove the Link - Aft - Upper - Rear - LH (Remove and Replace).
- Remove the Link - Fore - Lower - Rear - LH (Remove and Replace).
- Remove the Link - Fore - Upper - Rear - LH (Remove and Replace).
- Remove the Carpet - Rear Trunk (1-Piece) (Remove and Replace).
- Remove the Busbars - Charge Port to HV Battery (NACS) (Remove and Replace).
- Remove the Trim - Side - Trunk - RH (Remove and Replace).
-
Remove the Rear Damper Mount Upper.
-
Remove the original component.
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolt to 24 Nm.
-
Install the Rear Damper Mount Upper.
- Install the Trim - Side - Trunk - RH (Remove and Replace).
- Install the Busbars - Charge Port to HV Battery (NACS) (Remove and Replace).
- Install the Carpet - Rear Trunk (1-Piece) (Remove and Replace).
- Install the Link - Fore - Upper - Rear - LH (Remove and Replace).
- Install the Link - Fore - Lower - Rear - LH (Remove and Replace).
- Install the Link - Aft - Upper - Rear - LH (Remove and Replace).
- Install the Drop Link - Stabilizer Bar - Rear - LH (Remove and Replace).
- Install the Spring - Rear Suspension - LH (Remove and Replace).
- Install the Subwoofer (Remove and Replace).
- Install the Damper - Rear - LH (Remove and Replace).
- Install the Knuckle - Suspension - Rear - LH (Remove and Replace).
- Install the Wheel Arch Liner - Rear - LH (Remove and Replace).