2025-08-06

Parcel Shelf Extension (Rear)

Correction code: 10101910802 10101911402 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds

    or Factory SPRs

  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short

    or Flow Form Rivets, S18

    Informational PurposesAn informational icon, calling your attention
    Note
    Install one countersunk rivet on each side of the original factory SPR location, as shown below.
  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.