Rear Jack Pad Bracket
Correction code:
10102902702
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASSEMBLY - REAR JACK PAD (Rear Jack Pad Bracket) | |
| 8 | Structural Bulb Rivet, 6.5 mm | |
| 2 | High Strength Structural Rivet, 6.5 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the necessary portion of the
Body Side Outer Assembly to expose the underlying
component being replaced.
-
Remove the original component.
- or Factory Spot Welds
- Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the portion of the Body Side Outer Assembly that was removed to expose
the component being replaced.
-
Install the High Strength Structural
Bulb Rivets on the bottom flange of the Rear Jack Pad Bracket.
NoteA red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
- Perform any necessary post-repair operations.