03/07/2024 15:59:02

Front Subframe Mount (Rear)

Parts List

Quantity Description Image / Notes
1 MY ASY-FR SUBFRM MNT REAR LH SVC E-COAT (Front Subframe Rear Mount)
9

High Strength Structural Rivet, 6.5 mm

2

Bolt BOLT,HF,M10-1.5x30,[109],ZNFL,SMAT

 Tesla part number 1111151-00-A.

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the Dash Crosmember.
  2. Remove the original component.

    or Factory Spot Welds

    or Bolts

  3. Prepare for installation.

    or Steel Plug Welds

    or High Strength Structural Rivets, 6.5 mm
    • A = 25 mm
    • B = 22 mm

    or Bolts

  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
    Torque the bolts to 35 Nm.
  6. Perform GMA welding.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install a 6 mm steel plug weld in each marked location.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to Approved Gas Metal Arc (GMA) Welders and Welding Wire for information on approved GMA welders and welding wire.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
    Informational PurposesAn informational icon, calling your attention
    Note
    Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.
  7. Install the Dash Crosmember.
  8. Perform any necessary post-repair operations.