Rear Center Trough
Correction code:
10101910302
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | Rear Center Trough | |
| 4 | Countersunk Rivet, 4.8 mm Short | |
| 10 | Rivet, 4.8 mm | |
| 2 | Flow Form Rivet S18 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Carpet - Rear Trunk (1-Piece) (Remove and Replace).
- Remove the Trim - Side - Trunk - RH (Remove and Replace).
- Remove the Trim - Side - Trunk - LH (Remove and Replace).
- Remove the Power Trunk (Remove and Install).
- Remove the Glass - Backlight (Heat Pump) (Remove and Install).
-
Remove the original component.
Factory Spot Weld
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform resistance spot
welding.
WarningFailure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.CAUTIONDo not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
- Install the Glass - Backlight (Heat Pump) (Remove and Install).
- Install the Power Trunk (Remove and Install).
- Install the Trim - Side - Trunk - LH (Remove and Replace).
- Install the Trim - Side - Trunk - RH (Remove and Replace).
- Install the Carpet - Rear Trunk (1-Piece) (Remove and Replace).