03/07/2024 16:00:31

Rear Spring and Subframe Mount

Parts List

Quantity Description Image / Notes
1 M3 Asy-Rr Spring & SubFr Mt (Rear Spring and Subframe Mount)
51 High Strength Structural Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the Trunk Floor Assembly (Complete).
  2. Remove the Rear Wheel House Rear Stiffener.
  3. Cut the Wheelhouse Inner as shown and bend back the cut section to expose the spot welds underneath.
    Cut Line
    • A = 95 mm
  4. Remove the original component.

    Bolt

    Factory SPR

    Factory Spot Weld

    Factory Spot Weld Area

  5. Prepare for installation.
  6. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply adhesive to the mating surface of the cut section of the Wheelhouse Inner.
  7. Install the new component or components.
    Informational PurposesAn informational icon, calling your attention
    Note
    Bend the cut section of the Wheelhouse Inner back into position before installing the bolts in that area.
    Informational PurposesAn informational icon, calling your attention
    Note
    Torque the bolts to 24 Nm.
  8. Install the Rear Wheel House Rear Stiffener.
  9. Install the Trunk Floor Assembly (Complete).
  10. Perform any necessary post-repair operations.