Rear Aero Shield Attachment Bracket (Rear)
Correction code:
10101815602
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY - RR AEROSHIELD RR BRKT (Rear Aero Shield Rear Attachment Bracket) | |
| 3 | Rivet, 4.8 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Carpet - Rear Trunk (1-Piece) (Remove and Replace).
- Remove the Bumper Beam - Rear (Remove and Replace).
-
Remove the original component.
or Factory Spot Welds
-
Mark the mounting location for the Rear Aeroshield Bracket on the Rear
Panel.
Reference Line/Point
- A = 21 mm
- B = 96 mm
- C = 63 mm
-
Prepare for installation.
Reference Line/Pointor Rivets, 4.8 mm
- D = 40 mm
- E = 24 mm
- F = 33 mm
- G = 25 mm
- H = 45 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Bumper Beam - Rear (Remove and Replace).
- Install the Carpet - Rear Trunk (1-Piece) (Remove and Replace).