Rear Frame Rail Glove (Lower)
Correction code:
10101813602
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY - RR RAIL GLOVE LOWER (Rear Frame Rail Glove – Lower) | |
| 8 | High Strength Structural Rivet, 6.5 mm | |
| 7 | Structural Countersunk Rivet, 6.5 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Seal - Trunk (Remove and Replace).
- Remove the Air Extractor - LH (Remove and Replace).
- Remove the Bracket - Taillight - LH (Remove and Replace).
- Remove the Bumper Beam - Rear (Remove and Replace).
- Remove the Bracket - Rear - Center (Remove and Replace).
-
Remove the Rear Body Panel.
-
Remove the Rear Frame Rail to Lower Quarter Extension.
-
Remove the Trunk Floor Assembly (Side Panel).
-
Remove the original component.
or Factory Spot Welds
or Factory SPRs
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the Trunk Floor Assembly (Side Panel).
-
Install the Rear Frame Rail to Lower Quarter Extension.
-
Install the Rear Body Panel.
- Perform any necessary post-repair operations.
- Install the Bracket - Rear - Center (Remove and Replace).
- Install the Bumper Beam - Rear (Remove and Replace).
- Install the Bracket - Taillight - LH (Remove and Replace).
- Install the Air Extractor - LH (Remove and Replace).
- Install the Seal - Trunk (Remove and Replace).