2026-02-28

Toeboard Outer

Correction code: 10101017102 10101003402 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Procedure

  1. Remove the Carpet - Front - LH (Remove and Replace).
  2. Remove the HV Battery (RWD) (Remove and Install).
  3. Remove the IP Carrier (Remove and Install).
  4. Remove the Brake Pedal (Remove and Replace).
  5. Remove the original component.

    or Factory Spot Welds

    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  6. Prepare for installation.
  7. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  8. Install the new component or components.
  9. Perform any necessary post-repair operations.
  10. Install the Brake Pedal (Remove and Replace).
  11. Install the IP Carrier (Remove and Install).
  12. Install the HV Battery (RWD) (Remove and Install).
  13. Install the Carpet - Front - LH (Remove and Replace).