Fender Attachment Bracket (Lower)
Correction code:
10100122002
10100122102
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | M3S FENDER ATTACHMENT BRACKET LOWER (Fender Attachment Bracket Lower) |
These part numbers were current at the time of publication. Use the revisions listed or later, unless otherwise specified in the Parts Catalog.
Repair Procedure
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
or Steel Plug Welds
- Install the new component or components.
-
Perform GMA welding.
or Steel Plug Welds
WarningFailure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.CAUTIONDo not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.