2025-08-06

Front Floor Extension

Correction code: 10101001602 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Procedure

  1. Remove the original component.
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
    or Factory Spot Welds
    Informational PurposesAn informational icon, calling your attention
    Note
    To access the spot welds circled in black, fold back the edge of the Center Underbody panel (shown in red).
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or High Strength Structural Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short

    or Countersunk Rivets, 4.8 mm Long
    • A = 263 mm.
    • B = 210 mm.
    • C = 158 mm.
    • D = 105 mm.
    • E = 11 mm.
  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.