Front Seat Mount Reinforcements (Vehicles Built Through January 4, 2023)
Correction code:
10100300602
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY – FSF SEAT MOUNT REINF (Front Seat Mount Reinforcement – Front and Rear Outboard) |
Note This part replaces all Front
Seat Mount Front reinforcements and the Front Seat Mount
Rear Outboard reinforcements. It does not replace the Front
Seat Mount Rear Inboard reinforcements. |
| 1 | MY ASY – REINF FSR CROSSMEMBER INBOARD SVC E-COATED (Front Seat Mount Reinforcement – Rear Inboard) |
Note This
part replaces only the Front Seat Mount Rear Inboard
reinforcements: it does not replace the Front Seat Mount
Front reinforcements or the Front Seat Mount Rear Outboard
reinforcements. |
| 1 | M3 FLOOR PANEL PATCH |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
For the seat mount
reinforcement being replaced, cut a hole in the underside of the floor panel
to access the damaged component.
Reference Line/Point
NoteDo not cut the floor panel under any mount that is not being replaced.NoteDo not damage the floor cross members when cutting the floor panel.NoteThe first image below is for the front seat front mount reinforcements. The second image is for the front seat rear mount reinforcements.Front mounts:- A = 564 mm
- B = 562 mm
- C = 104 mm
- D = 253 mm
- E = 56 mm
Rear outboard mounts:- F = 227 mm
- G = 433 mm
- H = 60 mm
Rear inboard mounts:- I = 128 mm
- J = 433 mm
- K = 60 mm
-
Remove the original component.
Factory Spot Weld Area
-
Cut the floor panel patch as
indicated below to make a cover for the floor panel repair area.
Cut Line
Reference Line/Point
- L = 78 mm
-
Prepare for installation.
NoteNew components are installed with structural adhesive only.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
NoteTemporarily secure the Seat Mount Reinforcement to the underside of the crossmember using a bolt or a clamp until the structural adhesive has cured.
- Perform any necessary post-repair operations.