Rear Motor Cover Floor
Correction code:
10101813502
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | Asy Fstnr-Floor, Rr Motor Cover (Rear Motor Cover Floor Panel) | |
| 23 | Structural Bulb Rivet, 6.5 mm | |
| 12 | High Strength Structural Rivet, 6.5 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Subframe Assembly - Rear (Remove and Install).
- Cooling System (Vacuum Refill).
- Cooling System (Check and Fill).
- Trim - Floor - Trunk (Remove and Replace).
- Seat Back - 2nd Row - LH (Remove and Replace).
- Seat Back - 2nd Row - RH (Remove and Replace).
- Carpet - Rear Trunk (1-Piece) (Remove and Replace).
- Trim - Side - Trunk - LH (Remove and Replace).
- Trim - Side - Trunk - RH (Remove and Replace).
-
Remove the original component.
Factory Spot Weld
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Trim - Side - Trunk - RH (Remove and Replace).
- Trim - Side - Trunk - LH (Remove and Replace).
- Carpet - Rear Trunk (1-Piece) (Remove and Replace).
- Seat Back - 2nd Row - RH (Remove and Replace).
- Seat Back - 2nd Row - LH (Remove and Replace).
- Trim - Floor - Trunk (Remove and Replace).
- Cooling System (Check and Fill).
- Cooling System (Vacuum Refill).
- Subframe Assembly - Rear (Remove and Install).