Fender Attachment Bracket (Upper)
Correction code:
10100103602
10100103702
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | M3S FENDER ATTACHMENT BRACKET UPPER (Fender Attachment Bracket Upper) | |
| 2 | High Strength Structural Rivet, 6.5 mm |
These part numbers were current at the time of publication. Use the revisions listed or later, unless otherwise specified in the Parts Catalog.
Repair Procedure
- Remove the Fender Assembly - Front - LH (Remove and Install).
- Remove the Door - Front - LH (Remove and Install).
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Door - Front - LH (Remove and Install).
- Install the Fender Assembly - Front - LH (Remove and Install).