2026-01-15

Rear Quarter Outer (Lower)

Correction code: 10101815702 10101815802 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Parts List

Quantity Description Image / Notes
1 PANEL - QUARTER OUTER EXTENSION PANEL (Rear Quarter Outer - Lower)
10 Structural Bulb Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the Trim - Floor - Trunk (Remove and Replace).
  2. Remove the Carpet - Rear Trunk (1-Piece) (Remove and Replace).
  3. Remove the Garnish - Trunk (Remove and Replace).
  4. Remove the Bracket - Taillight - LH (Remove and Replace).
  5. Remove the Bumper Beam - Rear (Remove and Replace).
  6. Remove the Bracket - Rear Wing - LH (Remove and Replace).
  7. Remove the Subwoofer (Remove and Replace).
  8. Remove the Wheel Arch Liner - Rear - LH (Remove and Replace).
  9. Remove the original component.

    or Factory Spot Welds

    or Factory SPRs

  10. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.
    or Structural Bulb Rivets, 6.5 mm
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the rivet circled in red connects all underlaying panels.
  11. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  12. Install the new component or components.
  13. Perform any necessary post-repair operations.
  14. Install the Wheel Arch Liner - Rear - LH (Remove and Replace).
  15. Install the Subwoofer (Remove and Replace).
  16. Install the Bracket - Rear Wing - LH (Remove and Replace).
  17. Install the Bumper Beam - Rear (Remove and Replace).
  18. Install the Bracket - Taillight - LH (Remove and Replace).
  19. Install the Garnish - Trunk (Remove and Replace).
  20. Install the Carpet - Rear Trunk (1-Piece) (Remove and Replace).
  21. Install the Trim - Floor - Trunk (Remove and Replace).