2025-01-08

Noise Absorber - Motor Bay - Front (Remove and Replace)

Correction code 12010102 2.76 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

Equipment:

1133569-00-A Pliers, Clip Removal

2025-01-08: Updated LH front door harness link to main front harness and added connector image for clarity.

Remove

Remove the brake booster. See #GUID-0CE8F156-928A-4338-A693-CF6EEB9055E6.
Remove the windshield washer reservoir. See Reservoir - Windshield Washer (Remove and Replace).
Remove the steering column control module. See .
Release coolant hoses from car computer. See .
Release the black connector from the right body controller and disconnect. See .
Remove the front dash noise absorber from the vehicle.

Install

Install the front dash noise absorber from the vehicle.
Connect black connector from right body controller and disconnect. See .
Connect coolant hoses from car computer. See .
Install the steering column control module. See .
Install the windshield washer reservoir. See Reservoir - Windshield Washer (Remove and Replace).
Install the brake booster. See #GUID-0CE8F156-928A-4338-A693-CF6EEB9055E6.