2025-03-23

LV Battery - Recover (Heat Pump) (Restore)

Korrigeringskode 17010008 0.06 MERK: Hvis ikke noe annet er uttrykkelig oppgitt i prosedyren, gjenspeiler korrigeringskoden og FRT ovenfor alt arbeidet som kreves for å gjennomføre denne prosedyren, inkludert de tilknyttede prosedyrene. Ikke stable korrigeringskoder med mindre du bli uttrykkelig bedt om det.MERK: Se Flat rate-tider for å lære mer om FRT-er og hvordan de lages. Hvis du vil gi tilbakemelding om FRT-verdier, kan du sende en e-post til LaborTimeFeedback@tesla.com. MERK: Se Personlig beskyttelse for å forsikre deg om at du bruker riktig PVU når du gjennomfører prosedyren nedenfor.

Informational PurposesAn informational icon, calling your attention
Merk
The LV battery won't recover unless the HV system is healthy and supporting the vehicle. Make sure that the HV system is functioning correctly before attempting to recover the LV battery .
  1. Remove the rear underhood apron. See Deksel under panser – bak (fjerne og skifte ut).
  2. Disconnect the LV battery connector and keep the first responder loop connected.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Release the green locking tab, pull the black connector lock outwards to release the connector, and then pull up to disconnect the connector.
  3. Connect the LV maintainer.
    1. Release the positive jump post cover.
    2. Attach the positive LV maintainer clamp to the positive jump post.
    3. Attach the negative LV maintainer clamp to the bolt head located between the brake fluid reservoir and the front trunk.
    4. Connect the LV maintainer to a power supply and switch it on.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ADVARSEL
    To avoid damaging the vehicle, DO NOT allow the positive terminal to make contact with any other metal components than the positive jump post.
  4. Connect the LV battery connector.
    Seat the LV battery connector on the LV battery, push the black connector lock inwards to engage the connector, and then seat the green locking tab after the lock is fully secured.
  5. Open LH front door and lower the window.
  6. Enable Service Mode. See Servicemodus.
  7. Disconnect the LV maintainer.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Power off the LV maintainer and release the connections from the vehicle. Reinstall the positive jump post cover.
  8. Bekreft statusen til lavspenningsbatteriet.
    • Hvis varselet VCFRONT_a478_LVBMS_MOSFET_Open er til stede 2 minutter etter PCS-støtte, har ikke lavspenningsbatteriet blitt automatisk gjenopprettet. Automatisk gjenoppretting kan forsøkes manuelt via berøringsskjermen eller Toolbox som beskrevet i neste trinn.
  9. Utfør følgende rutine med Servicemodus eller Toolbox (se 0005 – Servicemodi): PROC_VCFRONT_X_RECONNECT-LV-BATTERYvia Toolbox: (link)via Service Mode: Low Voltage ➜ Power Distribution ➜ Close MOSFET
  10. Hvis trinnene ovenfor ikke gjør at lavspenningsbatteriet automatisk gjenopprettes, må batteriet gjenopprettes med Tesla Li-Ion batterilader.
    • Kontroller at batteriet ikke lader ut ved høy strøm og ikke utfører selvbeskyttelse.
    • Gå til Service Mode (Servicemodus) > Low Voltage (Lavspenning) > Power Distribution (Strømfordeling) > LV Battery (Lavspenningsbatteri), og bekreft at lavspenningsbatteriets ladetilstand øker.
    • Kontroller at lavspenningsbatteriets MOSFET-status er Closed (Lukket).
  11. Exit Service Mode. See Servicemodus.
  12. Install the rear underhood apron. See Deksel under panser – bak (fjerne og skifte ut).