2019-03-07

Brakett – nummerskilt – foran (EMEA) (ettermontere ved hjelp av jigg)

Korrigeringskode 12070126 0.12 MERK: Hvis ikke noe annet er uttrykkelig oppgitt i prosedyren, gjenspeiler korrigeringskoden og FRT ovenfor alt arbeidet som kreves for å gjennomføre denne prosedyren, inkludert de tilknyttede prosedyrene. Ikke stable korrigeringskoder med mindre du bli uttrykkelig bedt om det.MERK: Se Flat rate-tider for å lære mer om FRT-er og hvordan de lages. Hvis du vil gi tilbakemelding om FRT-verdier, kan du sende en e-post til LaborTimeFeedback@tesla.com. MERK: Se Personlig beskyttelse for å forsikre deg om at du bruker riktig PVU når du gjennomfører prosedyren nedenfor.

  • 1496772-00-A Nummerskiltholder foran jigg, Model 3, EMEA

Prosedyre

  1. Clean the front center surface of the front fascia with isopropyl alcohol (IPA) wipe, and then allow surface to dry before continuing.
  2. Put the front license plate bracket on the jig: Line up the 2 holes on the front license plate bracket with the alignment pins on the jig.
  3. Put the jig on the front fascia: Line up the center indicator (cut out slit) with the center of the front fascia grille.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply enough force on the head of the jig causing an even contact surface with the front fascia grille and the front license plate bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to hold the jig by placing your hand on the head of the jig.
  4. Wear eye and ear protection before continuing.
  5. Use a 7/64 in (3 mm) drill bit to drill 4 holes through the front fascia.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Only drill through the top surface of the front fascia. Drilling too far can result in damage to the vehicle.
  6. Install the self tapping screws (part number 1104972-00-A) (x4) that attach the front license plate bracket to the front fascia.
    1 Nm (.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not over torque the screws to prevent damage to the front fascia.
  7. Remove the jig by sliding it out from the front fascia grille