2026-06-10

Frontlys (SAE-til-global) – frontlys – par (ettermontering)

Korrigeringskode 174001060,72 MERK: Hvis ikke noe annet er uttrykkelig oppgitt i prosedyren, gjenspeiler korrigeringskoden og FRT ovenfor, alt arbeidet som kreves for å gjennomføre denne prosedyren, inkludert de tilknyttede prosedyrene. Ikke stable korrigeringskoder med mindre du bli uttrykkelig bedt om det. MERK: Se Flat rate-tider for å lære mer om FRT-er og hvordan de lages. MERK: Se Personlig beskyttelse for å forsikre deg om at du bruker riktig PVU når du gjennomfører prosedyren nedenfor. MERK: Se Forholdsregler for ergonomi for trygge og sunne arbeidspraksiser.

  • 2026-05-22: Removed reference to obsoleted Tech Note TN-24-17-002 and added some additional info from TN-24-17-002 on the retrofit.
  • 2024-06-27: Updated Toolbox 3 headlamps configuration "Global" direction.
Informational PurposesAn informational icon, calling your attention
Merk
For proper headlamp operation in Model 3 vehicles, both headlamps must be of the same type (Global or SAE), and the vehicle software configuration must match the installed headlamp type. If one headlamp is damaged, and the replacement headlamp is not the same type (Global or SAE) as the undamaged headlamp, the undamaged headlamp must also be replaced. If an SAE type headlamp is damaged, replace both the damaged and the undamaged SAE headlamps with Global headlamps.

Ettermontere

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Remove the LH and RH headlights. See Frontlys – venstre (fjerne og skifte ut).
  4. Install the new LH and RH headlights. See Frontlys – venstre (fjerne og skifte ut).
    Informational PurposesAn informational icon, calling your attention
    Merk
    Do not adjust the headlights at this time. Headlight adjustment will be performed later in this procedure.
  5. If not already performed, enable Service Mode through the touchscreen. See Servicemodus.
  6. Enable Service Mode +. See Servicemodus Pluss.
  7. In Toolbox 3, click on the Dashboards tab, search for “infotainment”, click Infotainment Dashboard > Vehicle Configuration > headlamps, and then change the "headlamps" configuration to "GLOBAL".
    Informational PurposesAn informational icon, calling your attention
    Merk
    If you do not see this configuration displayed, update the vehicle to software version 2024.20 or later.
  8. On the vehicle touchscreen, perform a software reinstall concurrently with the rest of the steps in this procedure. See Installer programvare på nytt – berøringsskjerm.
  9. If the vehicle is equipped with a Virtual Pitch Sensor (VPS), in Toolbox 3, click the Actions tab, search for “PROC_ICE_X_SET-VIRTUAL-PITCH-SENSOR”, and then click Change leveling system of Virtual Pitch Sensor.
    Informational PurposesAn informational icon, calling your attention
    Merk
    Make sure the vehicle is running firmware version 2024.8.9 or later to run this routine.
  10. Click Run and allow the routine to complete. Click X at the top right of the window to exit once the routine is complete.
  11. In Toolbox 3, go to Tools > Vehicle Configuration > headlightLevelerType and confirm the "headlightLevelerType" configuration is "VIRTUAL_PITCH_SENSOR".
  12. Disconnect the laptop from the vehicle. See Toolbox (koble til og fra).
  13. Adjust the headlights. See Frontlys – justere – global (verktøymetode).
  14. Disable Service Mode through the touchscreen. See Servicemodus.
  15. Raise the LH front window.
  16. Close the LH front door.