02/03/2023 16:32:57

Pinch Sensor (1st row) - LH (Remove and Replace)

Correction Code 11351202

Remove

  1. Remove the front door closeout panel (refer to procedure).
  2. Use a plastic trim tool to remove the push clips (x6) that secure the pinch sensor to the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Care must be taken to avoid damage to paintwork and exterior trim.
  3. Slide the pinch sensor trim out from under the door seal.
  4. Release the pinch sensor harness grommet by pulling it away from the door. Pull the pinch sensor harness out through the grommet in the rear of the door shell.
  5. Reach in through the door cavity and release the fir tree clip that secures the pinch sensor harness to the door.
  6. Remove the pinch sensor from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace any broken clips.
  1. Ensure proper operation of the pinch sensor.