Rear Trunk Floor Panel Extension

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	EXTENSION - RR TRUNK FLOOR PNL (Rear Trunk Floor Panel Extension)
LH component: 8 RH component: 6	Structural Bulb Rivet, 6.5 mm
LH component: 4 RH component: 3	Rivet, 4.8 mm
3	Bolt, hex-head , M8-1.25x20	Tesla part number 1007580-00-A.

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the original component.

or Factory Spot Welds

or Drill through factory spot welds
Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.

or Bolts, hex-head
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced.
or Structural Bulb Rivets, 6.5 mm
- A = 60 mm.
- B = 11 mm.
or Rivets, 4.8 mm

or Bolts, hex-head
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Torque the bolts to 24 Nm.